
Dimensions AT-B5 (in mm. 1 mm = 0.0394 inch)
Dimensions AT-B5 (in mm. 1 mm = 0.0394 inch)
Bottom view
16
Dimensions AT-B5 (in mm. 1 mm = 0.0394 inch)
16
Back view
51
23.5
31.5
16
4
28.5
4
51
23.5
31.5
16
4
28.5
4
Top view
2-M3 terminal with cover
2-M3 terminal with cover
Remark
? ATTENTION: Remark areas (air gap) must be kept clean
contact
(particle free) to ensure proper performance
Connections
? Wires up to 2 mm ?
(AT transducer)
Mechanical characteristics
● Mechanical characteristics (air gap) must be kept clean
? General tolerance ± 1 mm
?
Primary aperture
? 16 mm
?
Fastening
Cable tie
Mechanicalcharacteristics
● General tolerance ± 1 mm
? aperture 16mm
● Primary ATTENTION: contact areas ? (air gap) must be kept clean
proper tie
● Fastening (particle free) to ensure Cable performance
Connections Connections
? 2 mm to
● Wires up to Wires up ? 2 mm ?
(AT transducer)
Remarks
ATTENTION: contact areas
General free) 1
? (particle tolerance ensure proper ± performance
? Primary aperture ? 16 mm
? Fastening Cable tie
(-)
(+) (-) (+)
K K
Ip
Ip
2 Measure +
2 Measure +
1 Measure -
1 Measure -
(-) (Controller, meter etc)
L
(Controller, meter etc)
090609/6
071115/4
(-) (+)
Load L
(Controller, meter, etc.)
reserves
LEM Load the right to carry out modifications on its transducers, in order to improve them, without prior notice.
(Controller, meter, etc.)
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
Page 3/3
www.lem.com
Page 3/3
www.lem.com
Page 3/3
071115/4
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
www.lem.com